Tridonic 22185154 PC 2×49 T5 PRO lp – Limited Stock

22185154 Technical Data

Mains voltage range 220 – 240 V
AC voltage range 198 – 264 V
DC voltage range 176 – 280 V (lamp start ≥ 198 V DC)
Mains frequency 0 / 50 / 60 Hz
Overvoltage protection 320 V AC, 1 h
Defined warm start ≤ 1.5 s
Operating frequency ≥ 39.5 kHz
Type of protection IP20

Lamp starting characteristics

Warm start
Starting time 1.5 s with AC and DC operation
Cathode heating will be strongly reduced after preheat time
Lamp operation
x II is the new benchmark in precise lamp operation. During the manufacturing process at Tridonic the ballasts are adjusted to optimum values. This reduces tolerances to a minimum and enables a very precise fix-frequent (equivalent to current controlled) lamp operation.

AC operation

Mains voltage:
220 – 240 V 50/60 Hz
198 – 264 V 50/60 Hz including safety
tolerance (±10 %)
202 –254 V 50/60 Hz including performance
tolerance (+6 % /-8 %)

DC operation

220 – 240 V 0 Hz
198 – 280 V 0 Hz certain lamp start
176 – 280 V 0 Hz operating range
Light output level in DC operation: 100 %

Emergency lighting

Use in emergency lighting installations according to EN 50172 or for emergency luminaires according to EN 61347-2-3 appendix J.
Instant start after mains interruption < 0.5 s
EBLF ≥ 0.5
Mains current for defective or missing lamps at
DC operation < 5 m

Other Information for the 22185154

RFI

Tridonic ballasts are RFI protected in accordance with EN 55015. To operate the luminaire correctly and to minimise RFI we recommend the following instructions:

• Connection to the lamps of the “hot leads” must be kept as short as possible (marked with *)
• Mains leads should be kept apart from lamp leads (ideally 5–10 cm distance)
• Do not run mains leads adjacent to the electronic ballast

• Twist the lamp leads
• Keep the distance of lamp leads from the metal work as large as possible
• Connect functional earth to the ballast, either over the terminal or over the mounting screw of the ballast
• Mains wiring to be twisted when through wiring
• Keep the mains leads inside the luminaire as short as possible

Installation instructions

IDC interface

• solid wire with a cross section of 0.5 mm² according to the specification from WAGO

Horizontal interface

• solid wire with a cross section of 0.5–0.75 mm² according to the specification from WAGO
• solid wire with a cross section of 1.0 mm² with an insulation diameter up to 2.5 mm
• strip 9 mm of insulation from the cables to ensure perfect operation of the push terminals
• Loosen wire through twisting and pulling

Tridonic are a Zumtobel Group company, founded in 1956 in Dornbirn, Austria. For more than 60 years, they have been a driving force in the development of professional lighting solutions.

Today, Tridonic is a world-leading provider of lighting technology for professional applications, including office buildings, and retail outlets, hotels and restaurants, the education industry and outdoor lighting sectors.

In Tridonics’ extensive range of energy-efficient dimmable and non-dimmable LED drivers they offer the right products for every indoor and outdoor application – from cost-efficient LED drivers in proven Tridonic quality to premium products that give you maximum flexibility and convenience.

Tridonics’ dimmable LED drivers can be controlled with different analog and digital dimming signals. Tridonic basicDIM Wireless products allow wireless control without additional wiring.