Tridonic 28004370 smartSWITCH G2 HF 5DP f

28004370 Common Data

Sensor type HF sensor
Rated supply voltage 220 – 240 V
Mains frequency 50 / 60 Hz
Frequency 5.8 GHz (± 75 MHz)
Transmission power < 0.2 mW

Load resistive 800 W
Load capacitive 400 VA
Detection angle 30 – 150 °
Max. detection area ø 8 m
Max. mounting height 5 m
Storage temperature ts -20 – 70 °C
Humidity min. 5 % … max. 85 % at 30 °C

Protection class Reinforced insulation
Housing material PC, halogen-free
Housing colour RAL 9016 (white)

28004370 Wiring

28004370 Wiring type and cross section

For wiring use stranded wire with ferrules or solid wire from 0.75 to 1.5 mm2.
Strip 8 mm of insulation from the cables to ensure perfect operation of the push-in terminals.
Use one wire for each terminal connector only.

Fixing conditions

Dry, acidfree, oilfree, fatfree. It is not allowed to exceed the maximum ambient temperature (ta) stated on the device. Minimum distances stated below are recommendations and depend on the actual luminaire.

Is not suitable for fixing in corner.

28004370 Wiring guidelines

• All connections must be kept as short as possible to ensure good EMI behaviour.
• Mains leads should be kept apart from LED driver and other leads (ideally 5 – 10 cm distance)
• Max. length of output wires is 2 m.
• To comply with the EMC regulations run the secondary wires (LED module) in parallel.

• Through wiring is not possible.
• Incorrect wiring can damage LED modules.
• To avoid damage of the Driver, the wiring must be protected against short circuits to earth (sharp edged metal parts, metal cable clips, louver, etc.).
• The current selection has to be installed in

28004370 Functions

Short-circuit behaviour

In case of a short circuit on the output side (LED) the LED driver protects itself.
After elimination of the short-circuit fault the LED driver will recover automatically.

No-load operation

In no-load operation the output voltage will not exceed the specified max. output voltage.

Overload protection

If the maximum load is exceeded by a defined internal limit, the LED driver will protect itself and LED may flicker. After elimination of the overload, the nominal operation is restored automatically.

Over temperature protection

The LED driver is protected against temporary thermal overheating.
If the temperature limit is exceeded the output current is reduced to limit tc at a certain level.

Tridonic are a Zumtobel Group company, founded in 1956 in Dornbirn, Austria. For more than 60 years, they have been a driving force in the development of professional lighting solutions.

Today, Tridonic is a world-leading provider of lighting technology for professional applications, including office buildings, and retail outlets, hotels and restaurants, the education industry and outdoor lighting sectors.

In Tridonics’ extensive range of energy-efficient dimmable and non-dimmable LED drivers they offer the right products for every indoor and outdoor application – from cost-efficient LED drivers in proven Tridonic quality to premium products that give you maximum flexibility and convenience.

Tridonics’ dimmable LED drivers can be controlled with different analog and digital dimming signals. Tridonic basicDIM Wireless products allow wireless control without additional wiring.